Sprayed MoS2 films emit laser-like light under continuous illumination
A peer-reviewed experiment combines solution-processed molybdenum disulfide layers with tiny optical resonators to produce laser-like emission at room temperature. Polymer spacers preserve the layers’ light-emitting properties while allowing thicker films. Changes in brightness, spectral width and polarization support the result, but the photon-correlation measurement needed for definitive confirmation of lasing remains unavailable.
Science··Evening
Polymer spacers preserve light-emitting layers
A peer-reviewed experiment obtained laser-like light at room temperature from films of molybdenum disulfide, written MoS2. Researchers separated sheets of this material in solution and sprayed them into a film. Poly(vinylpyrrolidone), or PVP, sits between adjacent sheets as a polymer spacer. This arrangement keeps the electronic behaviour of individual layers while increasing the amount of active material. Directly stacking the layers can change their optical properties, so maintaining separation is central to the design.[1]
A microscopic sphere recirculates light
The optical assembly couples the film to a silica sphere about 6 micrometres across, which acts as a resonator. Beneath the film are a silver reflector and a layer of polymethyl methacrylate, or PMMA, approximately 55 nanometres thick. During continuous optical pumping, the researchers observed a threshold-like change in brightness near 1.4 nanowatts, together with narrowing spectral lines and polarization selection. This power describes the experimental optical arrangement, rather than the electricity drawn by a finished light source.[1]
Film thickness changes optical gains and losses
A film about 13 nanometres thick contains several active-layer units. Adding thickness can increase interaction between light and the emitting material, but absorption and leakage also rise. Roughly a quarter of the tested devices showed no clear threshold, particularly with lower-quality resonators. The researchers retain the term laser-like because they could not obtain the photon-correlation measurement needed to establish lasing conclusively. Background light and leakage from several emitting sites complicated that measurement. The experiments used optical excitation rather than electrical pumping.[1]